EasyDSS in the video playback and push stream resource occupation is much higher than EasyNVR and other platforms, so for EasyDSS, in addition to the operation of the platform itself, we most often pay attention to the actual project EasyDSS has the capacity, if the equipment is too much, the server load and insufficient, It may cause the blockage of system operation.
For the excessive number of access equipment, it is not realistic to set the push flow separately for each way, so we can choose batch push flow, how EasyDSS concurrent batch push flow test, this article and you explain.
Srs-bench can be used for a wide range of performance tests, including load test, pressure test, etc. Load test can determine the maximum load that the system can withstand under the condition of meeting performance indicators, and pressure test can determine under what load conditions the system performance is in failure state. Obtain the maximum service level that the system can provide.
2. Download the SRS-bench after it has been compiled and installed
3. Then run EasyDSS to enter the Web page
4. To find the anonymous live stream, we run the following command on SRS server to push the live stream in batches
sb_rtmp_publish -i /opt/123.flv -c 10 -r rtmp://demo.easydss.com:10035/hls/1_{i}
5. As shown in the figure, push the normal batch stream to anonymous live broadcast
