“This is the second day of my participation in the November Gwen Challenge. See details of the event: The last Gwen Challenge 2021”.
Cisco Basic Network Connection and IOS basic operation “Network engineer road”
【 Objective 】
Understand and master the basic methods of simulator networking;
Understand and master the packet capture and viewing method in the simulator environment
Master basic switch operations
【 Network Topology 】
Network topology connection, as shown in Figure 1.
[Configuration Planning]
The IP addresses of the interfaces connecting the router to the left and right networks are 192.168.1.254/24 and 192.168.2.254/24 respectively.
The IP addresses of PC0 and PC1 are 192.168.1.1/24 and 192.168.1.2/24 respectively. The default gateway is 192.168.1.254.
The IP addresses of PC2 and PC3 are 192.168.2.1/24 and 192.168.2.2/24 respectively. The default gateway is 192.168.2.254.
【 Practice Tasks 】
\1. Construct the topology as shown in Figure 1;
\2. The IP address of the router interface connecting the left and right networks should be set as required; Set IP parameters for PC0, PC1, PC2, and PC3 as required.
\3. Ping PC1 on PC0 to check the connectivity. Switch to the analog mode, ping PC1 on PC0 repeatedly, and check the ICMP packet content and interaction.
\4. Ping PC2 on PC0 to check the connectivity. Switch to the analog mode, ping PC3 on PC0 repeatedly, and check the ICMP packet content and interaction.
